Wotech R32 small portable air to water pool heat pump for above ground
1.Above ground pools with compact design
2.Easy installation.
3.Plug & play mother board,easy service
4.Re-start memory
5.R32 system Environmental Friendly
6.Suitable for Koi ponds as well as swimming pools or sauna or SPA.
★ It's compact design,which is convenient during installation process.
ø We recommend air source heat pumps for the following types of properties:
1.Summer vacation rentals
2.Homes with low heat demands
3.Properties with limited outdoor space
4.Projects with smaller budgets
ø Here are some tips if you decide to install a pool heat pump yourself:
∧ Suitable Location
Choose a location for your heat pump where it can get a good flow of air. Optimum efficiency of the heat pump relies on good air flow. Where possible the heat pump should always be installed outdoors so it can receive a good supply of fresh air to operate and extract the heat from.
∧ Water Flow Rate
Most of our pool heat pumps state the required water flow rate on their specifications table. If the water flow rate is too low, then the water in the heat pump will overheat and the heat pump will switch off.
Check the water flow rate from your pool pump and through your filter to ensure that it is high enough for your pool heat pump.
∧ Base
The base for the heat pump should be level and sound. You can use either a concrete base, paving slabs laid on sand or timber decking.
The vibration from the heat pump will be fairly minimal and will not disturb the paving slabs.
The heat pump can be installed above or below water level. The only proviso is that the pool circulation pump is powerful enough to deliver the water flow rate that the heat pump needs to operate.
∧ Electrical Supply
Before purchasing a pool heat pump, you should check the running current and peak current stated on the listing for your desired model. Ensure that your electrical supply is adequate to support the running and startup currents for the unit.
It is normally recommended to run a dedicated cable back to your electrical consumer unit for the heat pump and install a dedicated breaker for the heat pump. Most heat pumps will have a higher electrical current demand when they start. This only lasts for a millisecond or so while the compressor starts and the current then reverts to the normal running current for the unit.
∧ Plumbing
It is easy to add a heat pump to an existing pool pipework system. First check to see what size of pipes you have.
| CODE |
WP03 |
| Advised pool size (m3) |
5~10 |
| Heating Performance Condition: Air 24ºC, Water 26ºC |
| Heating Capacity (KW) |
2.9 |
| COP |
4.9 |
| Heating Performance Condition: Air 15ºC, Water 26ºC |
| Heating Capacity (KW) |
2.2 |
| COP |
3.9 |
| Operating Air Temperature ºC |
10~43 |
| Power Supply (V/Hz) |
220-240V/1PH/50HZ |
| Rated Input Power(KW) |
0.59 |
| Rated Input Current(A) |
2.82 |
| Max Heating Current (A) |
3.6 |
| Water Flow Rate (m3/h) |
1.3 |
| Water Connection ( inch) |
1 |
| Sound level at 1m (dB(A)) |
56 |
| Net Dimension L*W*H(mm) |
420*370*440 |
| Qty per 20ft/40HQ(PCS) |
354/750 |
| Remarks:The Specifications are subject to changes without notice. |
Manufacturing & Laboratories:
Guangdong WOTECH Renewable Energy & Technology Co.,Ltd. was founded in 2005,integrating research and development,manufacturing,marketing and after sales service of heat pumps.Wotech has three production bases in Shunde,Zhaoqing and heyuan,covering area of 15 thousands sqm in total.
WOTECH heat pump series include swimming pool heat pump,air source water heater,drying heat pump and ventilation equipments,applied in hotes restaurants hospitals,swimmingpools,factories,pubilc leisure places,residential district and so on.
In 2016 WOTECH became the first public-listed heat pump company in China with stock code 835751.
WOTECH,with many years of heat pump export experience,sets up a top international quality control system,to achieve the belief of making best quality of heat pumps of global users.
Audited Supplier 
){kind=link}
){kind=link}